COVID-19 UPDATE: Expect 2-3 day preparation time for most orders. EPS Blanks are currently 3 week manufacturing lead time.

The EPS foam melted when installing FCS X-2. What did I do wrong?

In summertime heat (80 degrees ) the epoxy resin will tend to exotherm in deep holes as in FCS X-2 plug holes and ding repairs. FCS fusion, FCS II, and Futures are a tight fit and use very little resin so no worries there.


We recommend pouring only about a 1/2 ounce of epoxy into a hole at a time then waiting about an hour to fill up the rest of the hole. This will stop the epoxy from exotherming and melting EPS. 

Close (esc)

HEADS UP!

FREE SHIPPING on Orders over $35

**Excluding Surfboard Blanks but Shaping Kits ship for FREE too!

Age verification

By clicking enter you are verifying that you are old enough to consume alcohol.

Search

Shopping Cart

Your cart is currently empty.
Shop now