COVID-19 UPDATE: Expect 2-3 day preparation time for most orders. EPS Blanks are currently 3 week manufacturing lead time.

I am shaping a board with eps and rr 2000 epoxy. Planning on installing fcs x2 plugs but I've read a bit about melting foam. If I use glass inside the hole, make the hole snug and use ice packs should I be fine ? Do you recommend doing a two part pour ?

A two part pour is definitely the way to go. Just put a little resin in the bottom of the holes to set the plug and wait about an hour to fill the rest of the perimeter with resin. Use a dixie cup or something like that to drizzle the resin around the hole.
Close (esc)

HEADS UP!

FREE SHIPPING on Orders over $35

**Excluding Surfboard Blanks but Shaping Kits ship for FREE too!

Age verification

By clicking enter you are verifying that you are old enough to consume alcohol.

Search

Shopping Cart

Your cart is currently empty.
Shop now