Surf Foil High Density Mast Insert
Install this High Density Polyurethane Foam Foil Mast Insert into the bottom of your foil blank. (2) pockets for 10.5" centerfin channels are pre-routed and spaced at industry standard 3.50" [90mm] apart on center to accept the foil mast base plate.
Choose the insert with the fin boxes pre-installed or just the insert without fin boxes.
Use a 1 1/2" long router bit to install the insert.
12" x 5" x 1.50" deep
How to install a surf foil high density mast insert:
1. Trace the insert and hand route the pocket for a tight fit - or you can make a plywood template jig. If there's play in the box install lay pieces of innegra, carbon, or fiberglass in the pocket to take up space and provide more support.
2. Install the insert with epoxy resin, tape over the finbox slots so resin doesn't get in and laminate a patch over the insert with Innegra
or carbon and laminate the bottom of the board.
3. Cut through the reinforcement with a razor blade to remove the tape when the resin gels (about 45 mins - 1 hour).
4. Tape over the finboxes again and sealcoat with epoxy resin